What Should Automotive Plastic Part Manufacturers Consider When Designing?

　　In modern industrial production, automotive plastic part products are often encountered, and they are widely used. In the planning process of the automotive plastic part, some fundamental considerations cannot be ignored, and raw material automotive plastic part manufacturers can be said to be important promoters of automotive plastic part planning.

　　Since the policy of product development or product improvement is to make the product perform well and at the same time achieve low production costs, the design tasks of injection mold manufacturers should include the selection of raw materials, the selection of processing methods, strength calculation, and mold design, etc., automotive The same is true in plastic part planning.

　　Automotive plastic part manufacturers only need to consider these factors comprehensively and follow up systems to produce high-quality, commercially-effective molds. It must be emphasized that the practicality and cost efficiency of plastics are not certain, and planners must pay great attention to the correct solutions for material selection and processing.

　　Automotive plastic part manufacturers have a great influence on the production cost of plastic parts, and each design will determine the cost of production, automotive plastic part production, and assembly. As long as the advantages of the characteristics of plastic raw materials are fully utilized, costs can be saved in many aspects.

　　To achieve this goal of cost-saving, multi-functional integrated design, low-cost assembly technology, self-lubricating properties, and removal of surface treatment procedures can be used in automotive plastic part design, paying attention to wall thickness, mold, service, materials, etc.

　　When designing automotive plastic parts, automotive plastic part manufacturers must not only carry out the design and calculation of plastic products but also pay special attention to the gate design of the mold. It is necessary to select the correct gate system and the number and orientation of the gates because the type and orientation of the gate will have a greater impact on the quality of the product.